Go to the I/O tab on the diagnostics screen on the control.You can write a simple program in MDI mode to command the electrical output to the solenoid. Turn on the machine and use the control to activate the solenoid.Remove the exaust muflers from the solenoid and test the solenoid again.
A clogged exaust muffler can prevent the solenoid to operate correctly.Note: Do not use the machine before the air supply to the machine is correct. To move the solenoid out of the intermediate state, close the air valve and power off the machine. If you command the solenoid to open or close without the correct air pressure, the solenoid can go into an intermediate state that may not correct itself when the machine has correct air pressure.Side Mount (SMTC) - VF/VM/UMC/EC - Carousel and Pocket - Troubleshooting Guide.Tool Release Piston - Troubleshooting Guide.Refer to the following troubleshooting guides for more information: Turrets on ST model lathes, TRPs, and Side-Mount Tool Changer Pockets have specific troubleshooting steps.Do not expect the solenoid to operate correctly if the outlets are not connected to the system. Many solenoids will not shift correctly without correct air pressure and back pressure. Make sure the shut off valve is completely open. Make sure the machine receives the correct air pressure and flow.
0 kommentar(er)
